Textile glass. Staple fibres or filaments. Determination of average diameter1 Scope This International Standard specifies longitudinal profile and transverse section methods for determining the average diameter (i. e. the average value of actual diameters) of staple fibres or filaments in a textile glass product. This diameter must not be confused with the nominal diameter which is used in the designation of yarns and materials manufactured from these yarns and corresponds to the average diameter but rounded to the nearest

This part of ISO 3290 specifies requirements for finished steel balls for rolling bearings

segregation

Teams involved in construction

magnetic moment test methods

NOTE 1 Attention is drawn to the fact that this Part of BS 4825 does not cover the design of the clamps themselves

and that shall be satisfied by the information model implemented by the middleware

This method is applicable to high boiling material

this standard  gives the equivalent terms in the German language

The following technical modifications have been introduced during the revision:

The intent is that from all the available data an environmental description will be generated and compared to that set out in IEC 60721 (all parts) [16] 1

and mass of fine-grain structural steels products

The test is carried out on notched test specimens machined from moulded sheets/specimens or from finished products