End mill holder Weldon HSK 40 - 32 - 105Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

(applicable up to 21 bar)

without a tool

better chip evacuation

For measuring the groove diameter of shafts

After mounting

right angularity: 0

Measuring surfaces are carbide

reading parts brushed chromium-plated

For the chucking of quick change adaptors for taps

Repeating accuracy 0

All functional surfaces fine machined

Zero-setting at any position for incremental measurement