Identification of fuel assemblies for nuclear power reactors

Informative Annex A has been deleted

BS 1192 provides a ‘best-practice’ method for the development

The cavitation-pitting evaluation is based on the loss of material during a given time and under accurately defined operating conditions

special agreements apply with respect to the test procedure and the acceptance levels

— steam turbines and generators with outputs greater than 40 MW and speeds other than 1 500 r/min

This document specifies requirements for non-electrolytically applied zinc flake coating systems for steel fasteners

optional event

b) describes the importance of establishing scope for appraisal

BS EN 1846-2 provides test methods to check the firefighting and rescue service vehicle’s performance which ensures that it is efficient during the fire rescue

Sampling is useful in determining the characteristics of a material by obtaining representative samples from a lot of material

If these assignable causes can be identified as specified in ISO 3085

Tubes according to BS EN 10305-2 are characterized by having precisely defined tolerances on dimensions and specified maximum surface roughness