Triumph wrist pin bushing setKibblewhite Triumph wrist pin bushings are made from US Mill certified bearing bronze bar stock. Fits all 650 rods 1950 1972, and all pre unit 500 rods. No oil hole is provided, this is best drilled after installation and before reaming or honing. These bushings must be sized after installation. Replaces Triumph part number 70 1511. 0. 8148" OD x 0. 688" ID x 1. 031" OAL Sold in pairs, made in USA

57-0023 KICKSTARTER SPINDLE BUSHING x1

These are also the inserts used for pre unit "conversion" rods (like Thunder Engineering and LF Harris)

DEPENDING ON YOUR INSTALLATION HEIGHT SEAT PRESSURE WILL VARY

(if you are looking for a non setting sealant please see the Hylomar page)

032" thick

Lucas rotor is available separately by clicking here

these are easier to install

Our extensive installation notes should answer any questions you might have about these piston rings

305" installed height

Available in sizes 15

Amal part # RKC/510

This kit is designed to service the top end on 1971 Unit 650 engines with dowel pins in head